Near miss: Steam and water released from filter

  • Safety Flash
  • Published on 3 May 2023
  • Generated on 3 April 2025
  • IMCA SF 11/23
  • 2 minute read

Steam and water were unexpectedly released from a filter when a mechanic was cleaning out strainers from a boiler circulation pump.

What happened?

A mechanic was given a work order to clean out strainers from a boiler circulation pump.

The mechanic was loosening the last two bolts, and stopped to wait to hear a “pop” indicating the lid coming up. The “pop” was a little bit more than was expected.

As the mechanic waited for approximately 10 seconds, it was noticed that the pressure started getting more volatile with more air and water coming out.

The mechanic moved out of the way, and called the control room to let them know what was going on.

An operator and a supervisor responded and went to a valve that they thought might still be partially open. They attempted to try and close it.

The supervisor tried with a bigger valve wrench and was able to turn the valve two more turns to close it off.

Mechanic was cleaning out strainers from a boiler circulation pump

What went right?

The employee moved out of the way after noticing increased pressure from the filter.

The supervisor was able to close the valve two more revolutions after the incident.

What went wrong?

The valve did not fully close when operations attempted to isolate it.

Lessons learned

Procedures were changed so as to:

  • Open the bypass on the filter first, then isolate the inlet and outlet of the filter.

  • Open drain valves upstream and downstream and then open the purge upstream and downstream, ensuring zero energy is exhausting.

Latest Safety Flashes:

LTI: rope under tension moved and hit person’s hand

A member of the crew suffered a serious hand injury when struck by a rope under tension.

Read more
Injuries during lifting operations

A member reports two separate lifting activities involving failure of lifting equipment and resulting in minor injuries to nearby personnel.

Read more
Finger injury during manual handling

An IMCA’s members’ utilities supplier in the United States reports a serious finger injury during manual handling

Read more
Acetylene gas explosion

There was a small explosion and fire when crew were working on an oxy-acetylene system.

Read more
Crane cab fire caused by fridge

On a vessel alongside, there was a fire in the cab of a crane.

Read more

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.

The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.

All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.

IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.

The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.

Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.