Dangers when mooring and unmooring

  • Safety Flash
  • Published on 1 August 2003
  • Generated on 9 July 2026
  • IMCA SF 09/03
  • 2 minute read

A recent near-miss was reported on a Member’s vessel, whereby a rigger was nearly hit by a mooring line during a mooring operation.

What happened?

The rigger was operating the capstan when it happened. In the past, a number of near misses have occurred and unfortunately also a number of very serious accidents whereby people sustained extensive injuries.

Mooring and unmooring of barges and ships has always been a hazardous operation. Clearly, not all parts of a mooring operation can be planned without good co-operation and communication with the crew of the facility or other vessel.

The company involved has made the following recommendations:

To enhance such co-operation and communication, with the aim of eliminating such incidents, the member has noted the following points in its procedures:

  • Always have a ‘toolbox talk’ prior to any mooring/unmooring operation and keep to the agreements made.
  • Follow the correct (agreed) sequence.
  • Always stand clear of areas where you can be hit by a breaking line or a jumping line.
  • Check the condition of the mooring lines before use – if their condition is unacceptable, scrap them.
  • If you end up in a situation where the situation is hazardous, stand back and/or stop the operation and make sure it is safe before proceeding; . Communication between deck and foreman on barge needs to be operating properly in case of sequence changes or otherwise.

Latest Safety Flashes:

Severe injuries following falling off a freight container

A truck driver slipped and fell from a container leading to severe injury.

Read more
Watertight doors left open

Watertight doors in the Engine Room and fire doors in the accommodation were observed open on several occasions during a management audit.

Read more
Crew member injured during mooring operation

A crew member used their foot to slow down a running mooring rope, causing them to fall to the deck.

Read more
Worker got something in the eye – safety glasses slightly askew

A workers safety glasses were slightly offset (creating a small gap) which allowed a fragment of hot slag to get in his eye.

Read more
Fire in tumble dryer

A fire was discovered within one of the vessel laundry dryers.

Read more

IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.

The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.

All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.

IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.

The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.

Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.