Diver fainted
- Safety Flash
- Published on 20 March 2015
- Generated on 26 December 2024
- IMCA SF 04/15
- 2 minute read
Jump to:
A member has reported an incident in which a diver fainted.
What happened?
The incident occurred when the diver arrived at the stage feeling very tired and requested permission to enter the bell without removing his chemical oversuit (barrier suit), (which was being worn due to potential seabed contamination). The dive supervisor subsequently approved this request. Shortly thereafter the diver fainted. He was assisted into his seat where he regained consciousness with the bell being flushed simultaneously.
The other divers in the bell displayed no visible symptoms of fatigue or contamination. The diver then had a drink of water and the bell was prepared for recovery. The bell was recovered under normal procedure as planned at the end of the dive. After mating to the chamber system all divers entered the sat complex as normal and without assistance.
Our member’s investigation noted the following:
- Enhanced diving procedures had been discussed with the offshore team and the bells were dressed appropriately; . It became apparen’t that correct procedures had not been followed before and during the incident, particularly the requirements to wear the built in breathing systems (BIBS) and remove the chemical oversuit; . The enhanced diving procedural checklist had not been formally retained.
Despite there being a potential for contamination, the incident was considered “a straightforward episode of faint” and the result of a number of contributory factors such as:
- Lack of food and drink.
- Working hard in the water (tidal flow).
- Balancing on the bell seat.
- Relief of hydrostatic pressure.
- Diver not removing his neck dam.
Our member identified the following lessons:
- Need to enhanced diving procedures, contingency procedures, associated check lists and use of such procedures appropriately for the work site.
- Need to review bell contamination exercise and carry out and record drills.
- Need to review dive site assurance process.
- Need to review method of storing and verifying diving operational checklists.
- Need to review company guidance with respect to precautionary decompressing divers after medical or health issues.
Related Safety Flashes
-
IMCA SF 10/07
20 December 2007
IMCA Safety Flashes summarise key safety matters and incidents, allowing lessons to be more easily learnt for the benefit of the entire offshore industry.
The effectiveness of the IMCA Safety Flash system depends on the industry sharing information and so avoiding repeat incidents. Incidents are classified according to IOGP's Life Saving Rules.
All information is anonymised or sanitised, as appropriate, and warnings for graphic content included where possible.
IMCA makes every effort to ensure both the accuracy and reliability of the information shared, but is not be liable for any guidance and/or recommendation and/or statement herein contained.
The information contained in this document does not fulfil or replace any individual's or Member's legal, regulatory or other duties or obligations in respect of their operations. Individuals and Members remain solely responsible for the safe, lawful and proper conduct of their operations.
Share your safety incidents with IMCA online. Sign-up to receive Safety Flashes straight to your email.